This is a PCB that acts as a SCART female-to-female coupler/gender changer, but extracts the audio from the input to a 3.5mm TRS jack, with multiple SCART variations available.
- Euro to Euro Extract (you probably want this one)
- JP21 to Euro Extract
I have several older game consoles that output their video and audio over SCART, and I often want to listen to the game audio with headphones.
I designed this board because the few products that extract audio from a SCART cable either terminate to RCA jacks, are out of stock, or do not support RGB.
This board must be right before your display! Audio is completely removed from the SCART cable, and you will not get audio from the output SCART connector. This coupler also does not support daisy chaining and removes the mostly unused D2B bus signals as well.
Create an issue if you would like a version that uses RCA jacks or JP-21.
The PCB, of which gerbers are available for in the releases. The PCB can be ordered from any board house, some examples of which are Oshpark, PCBWay or JLCPCB. Included in the releases are two versions, for PCBWay and JLCPCB respectively, which each have the board house's order number markers in the apropriate place.
2 Female SCART Connectors (specifically, KYCON_SCART_K-SCARTX-022_Horizontal). No major suppliers carry SCART connectors anymore as far as I'm aware, you can find listings on Aliexpress here (LR Ear), here (VER3) or here (03). Ensure that the part that juts out is on the top (opposite side of the pins), the connector has ears, is a horizontal/90 degree connector, has all 21 pins (to ensure RGB support), and does not have any extra mounting methods besides the ears (e.g, screw holes).
1 Female 3.5mm TRS Jack (specifically, Jack_3.5mm_CUI_SJ1-3523N_Horizontal). This can be bought from Mouser, Digikey or Aliexpress here, here or here.
Basic soldering equipment.
(Optional) Rubber feet or a case of some sort
Design a 3D printable shell to protect against shorts/damage to the board.