Address Mapping parameters not saving

[holminid]

Address Mapping parameters are not saved after they are entered. This happens after "update" and "save to flash" are pressed. The new addresses stay there until the OSM is powered off, after which they return to default values (/osm/a/cv etc). It seems like they’re in place, but even then there is no response when such messages are sent to the OSM.

[pingdynasty]

So after you've changed the address mappings (e.g. Receive CV A) and pressed Update, the module still responds to the old mappings?

[holminid]

Yes, that's right.

[pingdynasty]

What address are you putting in? There's a maximum address limit of 16 characters, including slashes.

[pingdynasty]

Actually only messages 12 characters or less seem to be working at the moment, I will investigate why!

[holminid]

I enter something like /mysoftware/acceleration/1
I could really use longer addresses since I can't hard code the OSM default values in the software I'm using. Any chance of this? Thanks!

[holminid]

I managed to change the addresses output from the app which worked, but then the network connection to the OSM was lost and the addresses were also gone. Can the module be reset somehow?

[pingdynasty]

Are you able to access the web interface? There's a Factory Reset option on the Status page.
If not, try switching to AP mode (hold WiFi button down for 6 secs) and reconnect to the module's network.

[holminid]

I can't always access the web interface. I have to power off the module and wait for it to reconnect.

[holminid]

We’ve been able to reconfigure our app to use shorter OSC addresses.
We managed to get it working twice only, on both occasions the OSM crashed and lost is AP state. Power cycling the module brings the AP back but all the edited OSC addresses are lost. 
The OSM is also not saving Local Port in Network Settings, or Value Ranges on power cycling.

We tested with the TouchOSC template and everything seems to be fine, but its of no use to us really.
We cannot test with GyrOSC as their addresses are too long and cannot be saved/edited.

Any help is greatly appreciated!

[pingdynasty]

Thank you for testing this out.
I'm working on longer addresses now, and also updating the core photon firmware to the latest release. This should help with general stability.

[pingdynasty]

Crashes may be due to OSC buffer overruns. Does it help to turn off Rotation Matrix, GPS and Qaternion messages in GyrOSC?

[holminid]

We can try turning rotation matrix and GPS off but we need quaternion (do those three cause problems?)

[pingdynasty]

They may cause problems because of the total size of the message being too big. Rotation appears to be the largest with 16 float values, if I understand it correctly.

[holminid]

We just sent 5-6 signals from GyrOSC to Osculator and then OSM. These included Rotation Matrix, GPS and Quaternion. It seemed stable, the crashing problem may have been elsewhere. I saw the firmware is updated, I guess we should try that next.